Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GAS HOB UNITS WITH GLASS RECESSED LID ▪
POSITIONING THE APPLIANCE
Proceed as follows to position the appliance on the support structure:
step
1
Position the gasket (sold separately) on the edges of the metal moulding or sealant paste (if present).
2
Position the appliance on the recessed hole and push it onto the support structure.
3
Secure the appliance by the fixing screws provided in the specific kit and screw them into the holes made at
the four corners of the metal moulding.
Note: make sure that the appliance is positioned properly in the slot before performing the final fixing.
The following are excluded from the aforementioned fixing system:
▪
models FC1345 and FC1348 which, since they do not have fixing holes, require an adhesive
to be placed on the external perimeter of the metal moulding for them to be glued directly
to the work table;
▪
model FC1352, which is fixed from the bottom in line with the bushings on the lower surface
of the perimeter edge of the hob unit.
ATTENTION!
There must be an opening below the hob of at least 50 x 50 mm for the passage of the gas
and electrical connections.
1
3
120
FC series
action
EQUIPMENT REQUIRED
4 x
4 x
2
Publicidad
Tabla de contenido
