Tabla de contenido
Publicidad
1. OPERATING INSTRUCTIONS FOR TEMPERATURE SETTING ON DIGITAL
EN
TEMPERATURE CONTROLLER
PT
EN
1. Press & hold switch 1.
2. To decrease temperature setting: While holding down switch 1, press switch 2.
3. To increase temperature setting: While holding down switch #1, press switch 3
4. Release all switches when temperature is set.
5. In normal position (without switch pressed) the digital readout shows the current
temperature of the inner chamber of oven.
6. Two temperature will be displayed, one on top as present value of temperature in Red
and below it in Green will be set value of temperature on digital temperature controller
(D.T.C)
7. When set temperature is reached, it cuts-off automatically. After 1-2 degree drop, the
oven switches on again.
8. Indicating bulb will glow red when heater is on.
2. SAFETY INSTRUCTIONS
5.1.
Never keep the quiver in a wet area or on a wet floor.
5.2.
Don't touch quiver surface with unprotected hands. Always use the insulation / safety
gloves.
5.3.
Make sure all electrical connections are secure.
AVISO:
Disconnect the Power Supply when quiver in not in use.
17
DRY OVEN ELECTRODES
EN
PT
EN
Publicidad
Tabla de contenido
