Tabla de contenido
Publicidad
TROUBLESHOOTING
Problem
Outdoor sensor is not
reporting to base unit
(gateway).
Dashes (--) on the app
or website.
Indoor and Outdoor
Temperature do not
agree during indoor
testing.
Indoor and Outdoor
Humidity do not
agree during indoor
testing.
Solution
Check that the outdoor transmission LED is
flashing normally (according to the sensor
reporting interval).
If the batteries were recently (re)placed, check
correct polarity was used and/or reseat the
batteries. If the batteries are old, replace them.
If the LED is now flashing normally, proceed to the
next step. If it is not flashing and you have repeated
battery checks and placement, you may have a
defective unit.
Make sure the gateway is powered and the WiFi
LED lights on steady. Go to the "Sensor ID" page,
find the offline sensor picture and press "Re-
register" to register.
During installation testing it is useful to test with
both indoor sensor and outdoor unit in the same
room. Allow up to one hour for the sensors to
stabilize and adjust to room temperature. The
indoor and outdoor temperature sensors should
agree within 2 °C (the sensor accuracy is ±1°C).
If these values still disagree, use calibration offsets
for one or both sensors to adjust to a known good
reference temperature.
The procedure here is that same as for outdoor/
indoor temperature. The sensors should agree
within 10 % (the sensor accuracy is ± 5 %).
If these values still disagree, use calibration offsets
for one or both sensors to adjust to a known good
reference humidity.
EN
81
Publicidad
Tabla de contenido
