Publicidad
EN
INFORMATION
SAFETY ADVICE & CAUTIONS!
These products may represent a possible shock or fire hazard if improperly installed or attached
•
•
in any way. Products should be installed in accordance with the user manual, current electrical
codes and/or the current National Electric Code (NEC).
Though This fixture is IP67 with weather protection and can stand high humidity environments
• •
you have to carefully plan the fixture plug positioning and protection. The connection between
the fixture plug to the electric plug should be water protected by a weatherproof outdoor
electric box.
The grow light is suitable for use indoor, outdoor - beneath a ceiling mounted receptacle,
• •
or any other structure.
This appliance can be used by children aged from 8 years and above and persons with reduced
• •
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
In order to prevent possible electric shock or leakage current, never use the appliance with wet
• •
hand or operate the appliance when there is water on the power cord.
If using a stepladder or power tools please make sure that you follow the manufacturer's
• •
safety advice.
TOOLS & EQUIPMENT
… 1 person needed
…
… Cordless Drill -
…
Philips Bit
… Wrench
…
10mm 3/8"
BEFORE ASSEMBLY
Please read these instructions carefully before you start to assemble this product.
1.
Please carry out the steps in the order set out in these instructions.
2.
Keep these instructions in a safe place for future reference.
3.
These instructions are compatible with Palram - Canopia's range of Greenhouses.
4.
DURING ASSEMBLY
Please make sure that your electrical system is ready and working properly up to the point
•
•
of connection of the cord plug.
In this instruction manual we show the Brighton - LED Grow Light's assembly onto a
• •
Greenhouses.
The mounting of the Brighton - LED Grow Light's is performed onto the screws slots
• •
in the aluminum profiles.
IMPORTANT ASSEMBLY STEPS
When encountering this information icon during assembly,
please refer to the relevant assembly step for important
additional comments.
Steps 6+7:
For Greenhouses Grand Gardener, Hobby Gardener, EcoGrow,
Prestige and Sun Room 6'+8' use screw #7442, as shown in the
Diagram b.
Step 12:
Refers to Extensions only.
Some of the steps are irrelevant for an assembly of a single
• •
product.
When assembling a single or an extended product, some parts
• •
may be surplus.
Publicidad
