VENTE-UNIQUE WS-G-01 Manual De Usuario página 15

Control Panel & Remote Control Operation
BUTTON
ON (l). Enables all functions.
ON
OFF (O). Turns off all functions on control panel
and remote control.
OFF
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
POWER
TIMER button: Controls timer settings to turn
off fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
TIMER
FLAME button: Makes flame effect dimmer
and brighter.
NOTE: Flame effect stays on until power button
is turned off. Flame effect must be on for heater
FLAME
to turn on.
COLOR button: Makes the color flame effect
changing.
NOTE: color effect stays on until power button
is turned off. Color flame effect must be on for
COLOR
heater to turn on.
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater fan
will blow cool air for 8-10 seconds before the
HEATER
heater turns on, and after the heater turns off.
When the heater is first turned on, a slight odor may be present. This is normal and should
NOTICE
not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the
NOTICE
buttons too quickly. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the
FUNCTION
14
ACTION & INDICATION
1. Press ON (l). Power turns on. All functions
are enabled.
2. Press OFF (O). Power, flame effect, and all
functions turn off.
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit goes
to standby. All functions turn off.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is reached.
Indicator lights show setting.
1. Press once. Flame brightness effect gets
changing.
2. Press again. until desired setting is reached.
1.Press once. Flame color effect gets changing.
2.Press again until desired setting is
reached.total 3 colors.
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to allow
heater to cool down, then turns off.