Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HORNETPRO Remote Con-
FERRET 1 Channel System
Safety Information
Carefully read the following safety information before proceeding with installation, operation, or mainte-
nance of RF Solutions product. Failure to follow these warnings could result in death or serious injury
• This radio system must not be used in areas where there is a risk of explosion.
• Only qualified personnel should be permitted to access the transmitter and operate the equipment.
• Always follow operating information as well as all applicable safety procedures and requirements.
• You must satisfy the age requirements in your country for operating the equipment.
• Store in a safe place.
• Keep a clear view of the work area at all time before using, check it is safe to do so
Before maintenance intervention on any remote controlled equipment
• Do not open the receiver enclosure unless you are qualified.
• Disconnect all electrical power from the equipment.
Battery Precautions
• Risk of explosion if battery is replaced with a battery of an incorrect type.
• Do not short-circuit, disassemble, deform or heat batteries.
• Never attempt to charge a visibly damaged or frozen battery.
• Do not use or charge the battery if it appears to be leaking, deformed or damaged in any way.
• Immediately discontinue use of the battery if, while using, charging, or storing the battery, the bat-
tery emits an unusual smell, feels hot, changes color, changes shape, or appears abnormal in any oth-
er way.
Electrical Safety
ISOLATE the mains electricity supply before removing the cover and observe any relevant safety infor-
mation.
•
Maintenance to the product that involves removal of the cover should only be carried out by a compe-
tent person or qualified electrician.
• Ensure adequate protection on the Load circuit
• Refer to Product Datasheet for MAX operating Load.
• Product must be installed in accordance with the local country electrical regulations.
• A current limiting supply must be used in accordance with the datasheet
FERRET 1 Channel System
RF Solutions Ltd. Recycling Notice
Meets the following EC Directives:
DO NOT Discard with normal waste, please recycle.
ROHS Directive 2011/65/EU and amendment 2015/863/
EU
Specifies certain limits for hazardous substances.
WEEE Directive 2012/19/EU
Waste electrical & electronic equipment. This product must be disposed of through a licensed WEEE collection point. RF Solutions
Ltd., fulfils its WEEE obligations by membership of an approved compliance scheme. Environment agency number: WEE/JB0104WV.
2
HORNETPRO Remote Con-
Erase all Pairings
Effacer tous les appariements
Alle koppelingen wissen
Alle Kopplungen löschen
Borrar todos los emparejamientos
Cancella tutti gli abbinamenti
CR2032
Waste Batteries and Accumulators Directive
2006/66/EC
Where batteries are fitted, before recycling the prod-
uct,
the batteries must be removed and disposed of
at a licensed collection point. RF Solutions battery pro-
ducer number: BPRN00060.
11
Publicidad
Tabla de contenido
