Replace The Battery - Trust SWITCH-IN START-LINE ACDB-8000A Manual Del Usuario

EN
ACDB-8000A PUSH BUTTON FOR WIRELESS DOORBELL
1. Remove battery strip before use
A
Insert a flat head screwdriver into the notch on the
bottom of the push button and slide the push button
off the back plate
B
Open the waterproof rubber by flipping it open to show
the battery
C
Remove the plastic battery strip.
D
Close the waterproof rubber and place the push button
back on the back plate.
2. Pair push button with a receiver
While the receiver is in learn mode, send an ON signal to
pair the push button with the receiver.
Refer to manual of the receiver to activate the learn mode.
3A. Mount the push button with double-sided
tape
Determine where the push button should be placed.
Stick the supplied double-sided tape on the back and
attach the push button.
3B. Mount the push button with screws
A
Insert a flat head screwdriver into the notch on the
bottom of the push button and slide the push button
off the back plate
B
Determine where the push button should be placed and
mount the back plate with the supplied screws.
C
Place the push button back on the back plate by sliding
it from top to bottom on the back plate.
4

Replace the battery

When the battery is almost empty, the LED will light up
for 2 seconds and then flash 3x after pressing the push
button.
A
Insert a flat head screwdriver into the notch on the
bottom of the push button and slide the push button
off the back plate
B
Open the waterproof rubber by flipping it open to show
the battery
C
Take out the old battery and insert a new CR2032
battery. Note that the + side points upwards.
D
Close the waterproof rubber and place the push button
back on the back plate.
Combining Push Button with the Internet Control
Station (ICS-2000) or Smart Bridge
Combine the push button with the Internet Control Station
(ICS-2000) or Smart Bridge and receive a push notification
on your smartphone when the doorbell rings. For example,
this way you can easily create a silent doorbell.