EN
BEFORE FIRST USE
Remove all packaging materials and wipe the outside of the appliance with a damp
cloth.
Before using the appliance for the first time, it is recommended to let the appliance
complete a few toasting cycles without slices of bread on the highest browning setting
in a properly ventilated room.
OPERATION
1.
Plug the appliance into the mains socket.
2.
Put up to 2 bread slices into the slot at the top of the appliance.
•
Make sure the crumb tray is fully in place by pushing it firmly into the appliance
before using.
3.
Turn the browning control knob to the desired setting.
•
There are 6 settings: "1" for the lightest setting, "6" for the darkest setting.
•
You will need to experiment with this setting depending on your browning colour
preference and the thickness of the bread.
4.
Press the carriage lever down until it locks in the down position to switch on the
appliance.
•
The indicator light on the cancel button
•
Toasting process can be terminated at any time by pressing
will spring up.
5.
Once the bread has been toasted to the selected setting, the bread will
automatically pop up and the carriage lever will automatically spring up to switch
off the appliance.
•
During toasting, you may observe the toasting colour, if the browning setting is
higher than required, press
•
The indicator light on the cancel button
6.
Remove the bread from the slot.
IMPORTANT: If the bread gets stuck inside the appliance, do not attempt to dislodge
the bread when the appliance is plugged in. Remove the plug from the mains socket,
allow the appliance to cool down and carefully remove bread using wooden tongs.
7.
When you have finished using the toaster, unplug it from the mains socket.
Caution:
•
Do not toast the food with extremely runny ingredients such as butter.
•
The toast slot is only able to toast regular bread slice. Do not try to insert slices that
are too thick.
Reheating
•
To reheat cold toasted bread, press the carriage lever down vertically until it locks
in the down position to switch on the appliance and then press
•
The indicator light on the reheating button will illuminate to indicate the appliance
is in the reheating cycle.
will illuminate.
to stop the operation at any time.
will go out.
EN-4
. The carriage lever
.