Display The Temperature Of A Zone; Operating Mode Setting - Lamborghini Caloreclima Connect CRP Manual De Instalacion Y Uso

5.2

DISPLAY THE TEmPERATURE OF A ZONE

1. Go to the "SELECTED ZONE / ZONE CHANGE"
area
2. Press the button
appear in the box.
NOTE
The change occurs cyclically in all the configured zones.
Once the desired zone has been selected, the room temperature of the zone will be displayed in the center of the
main screen.
NOTE: The info indicated in the bottom running text and the MODE menu will refer to the selected zone.
5.3

OPERATING mODE SETTING

1. Select the desired zone with the
2. Using the and
, then confirm with the
M O D E
NOTE The possible zone modes are:
a. AUTOMATIC: The zone ambient set point is determined according to the time schedule.
b. MANUAL: The zone ambient set point can be set, and remains constant.
c. ZONE IN STAND BY: Zone heating/cooling requests are disabled.
NOTE When the system is in heating mode and the zone is off, an antifreeze function will still remain active,
that is, if the room temperature drops below 5 ° C, the Connect CRP will still switch on the system
3. Select the desired mode using the
tons.
4. Confirm with the
The current zone mode is indicated by the running text at the bottom of the main page.
94
EN
or the button to switch from one zone to another: the name of the selected zone will
button.
buttons, select the active area
button.
and
button.
cod. 3542B390 - Rev 00 - 06/2022
T U E
2 3 / 0 7 / 1 9
M E N U
T U E
2 3 / 0 7 / 1 9
M E N U
A U T O M A T I C P R O G R A M
but-
S E L E C T T H E O P E R A T I N G M O D E F O R
C R P
M O D E
2 7 . 5
° C
1 6 . 0 ° C
fig. 37
C R P
M O D E
2 7 . 5
1 6 . 0 ° C
fig. 38
C R P
A U T O M A T I C
M A N U A L
Z O N E O F F
fig. 39
1 2 : 1 9
1 2 : 1 9