EN
TOUR OF THE SUBWOOFER
Before you start, make sure all your equipment is switched off and the
amplifier volume is on low.
Make sure the subwoofer switch is in the OF F position, rotate the GAIN
control to MIN and set the FREQ control to the middle position. Plug in the
AC power cord to your electrical outlet.
Connect your subwoofer to your amplifier according to one of the diagrams
below. Turn on your amplifier and subwoofer and play your favorite music.
Gradually increase your amplifiers volume to your desired level. Gradually
increase your subwoofer GAIN lever t o your desired bass level. Adjust the
FREQ control to a point where the subwoofer and rear speakers perform
to your satisfaction. Toggle the PHASE switch between the REV and
NOR position to see which one sounds better to you. You can now leave
the AUTO/ON/OF F switch in the AUTO position. This position is Voice
Activated. Your subwoofer will switch on automatically only when the
subwoofer received an audio signal from your amplifier. For optimal results,
try a few different types of music.
Position
The subwoofer can be positioned anywhere in the room. For the best result,
position it between the rear speakers. It is best to try the subwoofer in a few
places around the room and check which one gives you the best listening
experience. To avoid unnecessary vibrations place the subwoofer on a solid
surface.
RUNNING TIME AND CLEANING
The performance of the subwoofer may change during the initial use due
to storage and mechanical limitations. Please allow 15 hours use for the
temperature effect and mechanical parts to attain their intended design
characteristics.
The cabinet only requires occasional dusting. Please avoid touching the
drive units.
17