Display Lighting - LaserLiner AirBreeze 360UV Manual De Instrucciones

3
Functions
Adjusting the fan speed
Four fan speeds can be selected.
Set timer
Press the button (10) to activate the automatic shutdown after 1, 4 or 8 hours.
Sleep mode
In sleep mode, the light sensor is activated which assesses the ambient light level. If the light level is low,
all lit displays on the device are dimmed and the fan is also automatically set to its lowest speed.
UV-C function (including ionisation)
Press the Anti-virus button (12) to start UV-C radiation and disinfection. Press and hold the button for
five seconds to start the ioniser.

Display lighting

To switch the air quality colour display on and off, press the Display button (13).
Filter reset
To reset the filter saturation display, press and hold the Display button (13) for 5 seconds.
This function is only available after the device has registered the filter has been changed.
4
Explanation PM 2.5
PM 2.5 fine particulate matter includes industrial emissions which can penetrate deep into the respiratory tract due
to their extremely small size, causing long-term damage to the lungs.
PM 2.5
Coloured indicator
Status
!
Note: Press the Display button (13) if you want to switch off the air quality display.
18
EN
0 ~ 50 μg/m 50 ~ 100 μg/m
3
blue green
perfect good
100 ~ 150 μg/m
3
purple
normal
150 μg/m ~
3 3
red
poor