Lloyd's LC-1342 Guía Rápida De Instalación página 27

8. How to disassemble the lock
1 Take the front handle and the rear handle from the packaging.
2 Remove the two screws on the battery cover to open the battery compartment.
3 Disconnect the connecting cable taking care not to break it.
4 Remove the two shortening screws for the connecting column and remove the rear handle.
5 Disassemble the lock body taking care not to tear the connecting cable.
9. Install the lock body
A. Adjust the size of the lock body according to the location
of the hole i n the door. (60 mm or 70 mm).
B. Check the opening direction of the door.
Left inside
Left outside
Note:
To verify if the direction of your door is left or right, look at it from the outside. If the hinges are on
the left side, the door direction is to the left, and vice versa.
C. Choose the latch position according to the opening direction of your door.
Inside
Outside
Inside
Outside
Left Right
inside outside
Right
inside
Right
outside
Left Right
outside inside
Inside
Outside
Inside
Outside
27