Samsung HW-S60B Manual página 12


(Sound Control)
By pressing the button, you can set the audio function. The desired item can be adjusted using the Up/
Down buttons. Each time the mode changes, the Multicolor LED blinks in white.
LED
Indicator
"SpaceFit Sound"
mode"
– Press and hold the
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/
Right buttons and each can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
– "Voice enhancement" makes it easier to hear spoken dialog in movies and TV.
– "Night mode" is optimized for night time viewing with the settings adjusted to bring the volume
down but keep the dialog clear.
– If the video on the TV and audio from the Soundbar are not synchronized, select "Sync" in Sound
Control, and then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
– "Sync" is only supported for some functions.
– The "Virtual" function can be turned On/Off by using the Up/Down buttons.

Bluetooth PAIR
Switch the Soundbar to Bluetooth pairing mode.
When you press the button, the LED display changes as shown below.
• Until pairing is complete, the Multicolor LED changes as Red → Green → Blue in turn.
LED
Indicator
p (Play / Pause)

You can also play or pause music by pressing the button.

" Active Voice Amplifier"
 "Sync"  "Virtual"
(Sound Control) button for about 5 seconds to adjust the sound for each
→ →
Red Green Blue Blinks
Pairing
"Ready to connect via Bluetooth."
White Blinks X1

"Voice enhancement"
ENG - 12

"Night
Cyan Blinks X3
Connection is complete