BEARWARE 303362 Manual página 11

7.3 Snoozing the alarm
Press the "SNZ/LIGHT" button to snooze an alarm. The alarm now sounds for the
snooze time previously set in the alarm settings and then sounds again.
7.4 Turning off the alarm
To turn off the alarm, press the "MODE", "ALARM", "UP" or "DOWN" button.
8. Night mode
The night mode dims the LED light during the night time. Press the "MODE" but-
ton twice in the time display. The display shows "OFF". Press the "DOWN" button
once. As soon as the display shows "ON", press and hold the "MODE" button until
the start time of the night mode is displayed. You can set this using the "UP" and
"DOWN" buttons. Confirm using the "MODE" button and repeat the procedure
for the end time. The setting sequence is as follows: Starting hour - Starting
minute - Ending hour - Ending minute.
The display is automatically dimmed during the set duration.
9. Manually dimming the LED light
Press the "UP" button to dim the backlight or to make it bright once again. Press
the "DOWN" button for 3 seconds to turn off the backlight
10. Temperature display
Press the "MODE" button once during the time display to display the temperature.
Press the "DOWN" button to change between °C and °F.
To change between temperature and time, press and hold the "MODE" button in
the temperature display until you hear a beep. The display now alternately shows
the temperature for 5 seconds and the time for 10 seconds. Repeat the procedure
if you want to switch off this mode.
11
English