Troubleshooting And Support; After Sales Service & Replacement Parts; Waste Disposal - Breville BAP009X Instrucciones De Uso

EN
14. Once removed the filter separation
plate will spring up to give access to
the lower filter. The plate can be rotated
upwards for better access (Figure 3).
15. Remove and discard the lower True
HEPA filter (Figure 4).
16. Insert two new True HEPA filters. Insert
the bottom filter first, then insert the top
filter (Figure 5).
17. To reattach the back panel cover, align
and mount the cover into the base of
the appliance first, and then push the
top of the panel against the appliance
(Figure 6).

TROUBLESHOOTING AND SUPPORT

For troubleshooting and FAQs visit www.breville.eu.
Problem Cause
The air purifier is not The appliance is not plugged in.
working.
The appliance is not switched on.
The filters are not properly
installed.
The panel cover is not fully
assembled.
The air flow has The air intake grille and filtered air
decreased. outlet may be obstructed.
The filter is nearing the end of its
useful product life.
Pre-installed filters are covered by
a protective plastic packaging.
The air purifier is making Pre-installed filters are covered by
a loud noise. a protective plastic packaging.
The ioniser function is operating.
6
BAP009X_21MLM2 (EMEA).indd 6-7 BAP009X_21MLM2 (EMEA).indd 6-7
18. Plug the unit and turn the power ON.
19. To reset the filter status on the air
purifier, press and hold the night mode
button for 3 seconds. The air purifier
will beep once. The filter replacement
indicator light will flash and beep 3
times and then turn off. The air purifier
is ready for use.
(See section 'Installing the True HEPA
filters' for Figures 1-6).
Warning: Only use the original Breville
filter model BAPF70 specially intended for
this appliance. Do not use any other filters.
Information on where to purchase
replacement filters can be found on our
website at www.breville.eu.
Solution
Check if unit is properly plugged in
and outlet is working.
Make sure unit is turned ON.
Make sure filters are properly
installed.
Check that the back panel cover
is correctly assembled. Align and
mount the cover into the base of
the appliance first, and then push
the top of the panel against the
appliance (Figure 6).
Turn OFF and unplug the
appliance. Remove any
obstructions blocking the air intake
grille and filtered air outlet.
Check the condition of the filters
and replace if necessary.
Check filters to remove any plastic
packaging and re-install the filters.
Check filters to remove any plastic
packaging and re-install the filters.
This is normal and occurs when a
small buildup of ions is discharged.
AFTER SALES SERVICE &
REPLACEMENT PARTS
In the case the appliance does not
operate but is under warranty, return the
product to the place it was purchased for a
replacement. Please be aware that a valid
form of proof of purchase will be required.
For additional support, please contact our
Consumer Service Department at
United Kingdom: 0800 028 7154 | Spain:
0900 81 65 10 | France: 0805 542 055.
For all other countries, please call +44 800
028 7154. International rates may apply.
Alternatively, e-mail: BrevilleEurope@
newellco.com.

WASTE DISPOSAL

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. E-mail us at
BrevilleEurope@newellco.com for further
recycling and WEEE information.
7
2022/1/27 3:17 PM 2022/1/27 3:17 PM
EN