Troubleshooting - Porter Cable 55000 Manual De Instrucciones

INSIDE COVER LENS REPLACEMENT
Replace the Inside Cover Lens if it is damaged (cracked, scratched, pitted or dirty)� Place your finger
or thumb into the recess and flex the Inside Cover Lens upwards until it releases from one edge�
Then remove any protective film before installing the new one�
CLEANING AND STORING
Keep the sensors, solar cell, and filter lens clean� Clean filter cartridge and helmet shell by using a
soapy water solution and soft cloth� Do not use solvents or abrasive cleaning detergent� Switch the
product to Grind Mode and put it in a clean, dry location for storage�
PROBLEM(S)
Difficult to see through filter
Filter does not darken when
arc is struck
Filter darkens without arc
Filter remains dark
after welding

TROUBLESHOOTING

POSSIBLE CAUSE(S)
Protective film on Front/Inside
Cover Lens not removed
Front/Inside Cover Lens dirty
Filter lens dirty
Grind mode selected
Sensors or Solar
Panel blocked
Set Sensitivity to LOW
Set Sensitivity to HIGH
Set Delay to MAX
5
SUGGESTED SOLUTION(S)
Remove protective film
Clean or replace Front/Inside
Cover Lens
Clean filter lens
Select Weld Mode and adjust
shade from 9 to 13
Make sure Sensors or Solar
Panel are exposed to weld arc
withouth blocking
Adjust Sensitivity to
required level
Adjust Sensitivity to
required level
Adjust Delay to
required level