Publicidad
2.
Carefully fit the wires back into the Junction Box.
3.
Slide the O-Rings onto the Machine Screws, and
then use a Phillips-head screwdriver to secure the
Mounting Bracket to the Plate.
4.
Ensure the Outer Ring is completely rotated
counter-clockwise.
5.
Align the 2 grooves inside the Floodlight to the 2
posts on the inner sides of the Bracket, and then
push the Floodlight into place.
Ensure there are no gaps around the perimeter
between the Floodlight and Bracket.
Tip!
Align the
6.
Twist the Outer Ring clockwise until the
symbols align.
7.
Tighten the pre-installed locking screw at the bottom of
the Mounting Bracket.
8.
Remove the Rubber Plug at the bottom of the Floodlight.
9.
Adjust the camera and LED Panels to the desired
position by loosening / tightening the screws on the LED
panel arms and the camera.
10.
Turn the power ON at the breaker. If the status indicator
does not turn on, check that the wiring is correct.
11.
Add the Floodlight to the
to the
symbol on the sides.
Lorex Home
and the
app.
Publicidad
