Artecristal VESTA Manual De Instrucciones página 8

Thermostatic shower column installation
As you mount the brackets for your new shower tray, the flow will influence your decision
on the mounting height of the unit:
1. It is recommended that the shower panel be mounted at a height that makes the unit
accessible to people of varying heights. In this way, several people in the house can
use the shower plate.
2. To determine the installation location for the shower panel, you will need to use a tape
measure and a pencil.
Taladre la pared
Instructions for mounting the shower panel
1. Two unit mounting brackets are used with two single bar straps.
2. Determine the distance between the upper and lower strap.
3. Determine the distance between the outermost measurement from the bottom of the
top strap to the bottom of the shower panel. Mark them on the mounting wall. The
distance between two straps can determine the mounting locations of two mounting
brackets.
4. Drill a hole in a flat mounting bracket against the wall with the mounting holes above
the mark indicating that the bracket is located on the center line. The mounting holes
should point toward the bottom of the shower bracket.
5. You will need to align this mounting bracket so that the curve of the bracket is on the
horizontal line. In the meantime, make sure the mounting holes are still centered on
the mark you made for the bracket location.
6. Mark the location of the two screw holes with the pencil.
7. Drill the location of each hole with a 5/16 '' diameter drill bit.
8. TIP: Pilot drill with a smaller bit before increasing to final size if the wall surface is
prone to chipping and cracking.
9. Place the wall anchors in the mounting holes you just drilled.
10. Using a screwdriver or drill, attach the mounting brackets to the wall surface with the
screws
Encaje los anclajes de pared
en los orificios de montaje
Pase los tornillos por los orificios de
los soportes y apriételos con los des-
tornilladores al máximo posible.