Installation; Placing The Stb; Connecting Cables; Using The Remote Control - IRIS 2300HD Manual De Instrucciones

16. .VOL+/-: Increase/decrease the channel's volume.
17. .EPG: (Electronic Programme Guide) turns
the programme guide ON/OFF.
18. UP/DOWN: Move the cursor up/down.to switch among channels.
19. RIGHT/LEFT: Navigates through the menus/
Increases or decreases the volume.
20. OK: Confirms an entry or selection/Displays the list of channels.
21. CH+/-: Channel pages up/down.
22. RED: Red function key.
23. GREEN: Green function key.
24. YELLOW: Yellow function key.
25. BLUE: Bule function key.
26. VIDEO: To the movie menu quickly.
27. REV: Searches backwards during media play.
28. FWD: Searches forwards during media play.
29. PLAY/PAUSE: Starts or resumes media play/pauses media play.
30. PREV: Skips to the previous media track.
31. NEXT: Skips to the next media track.
32. STOP: Stops media play.
33. REC: Used to record programme.
34. GOTO: Play the movie jump progress.

5. Installation

Placing the STB

5.1.
Place the STB on a stable table.
Note: Do not place anything on the STB. Leave over 10cm space around two sides of the STB for radiating.

5.2. Connecting Cables

For a basic connection from your Set Top Box to your television set, you can use Scart connection.
For a higher quality connection, use a direct HDMI connection, as shown below. Connect a audio
amplifier use coaxial is a optional.
Note: Before the operation, power off all devices to be connected
(for example, TV and STB)

Using the Remote Control

5.3.
Step 1 Open the battery box cover of the controller, insert 2 x AAA batteries
34