Starting + Stopping - SNOWJOE sunjoe 24V-PSW25 Manual Del Operador

m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
Operation

Starting + Stopping

m
IMPORTANT!
This spray washer is equipped with a
micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
m
WARNING!
Always remove battery before filling
with water. NEVER immerse unit in water. Close battery
compartment door securely before filling. Always use
caution when handling or using any powered product
where water is present.
1. Fill the water tank with clean water (Fig. 5).
Fig. 5
m
WARNING!
The intake water temperature must not
exceed 140ºF/60ºC.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
2. Open the battery compartment cover and slide the battery
in until it clicks to lock it into position, then close the
battery compartment cover (Fig. 6).
All manuals and user guides at all-guides.com
3. Position the washer as CLOSE as possible to the
4. Press the ON (I) side of the ON/OFF switch to start the
5. To shut down the unit, push the OFF(O) side of the
10
Fig. 6
Battery
object that need to be cleaned.
NOTE: The washer must be used on a secure and stable
surface in a standing, upright position.
portable washer and squeeze the spray gun trigger to use
the machine (Fig. 7).
Fig. 7
ON/OFF switch
NOTE: It's recommended to bleed the air in the hose
every time before starting the spray washer. Follow the
instructions in Maintenance section to bleed the air.
ON/OFF switch (Fig. 7), and remove the battery.