Care And Maintenance - Urrea USCS3 Manual De Usuario

E S P A Ñ O L
5. CAUTIONS
ATTENTION: To reduce the risk of serious injury
during use, follow these instructions.
•
Before using this welding helmet for
the first time the protective film that
covers the protection lenses must be
removed from both sides of the lens.
•
Make sure the helmet is always
equipped with internal and external
protective lens.
•
The inner lens protector is easily
removable by pushing outward from
inside the hull. To insert the lens, place
the lens under the two tabs that are
located on both sides of the main
opening.
•
The outer lens is held in position by a
plastic clip. To remove the inner clip
move toward the center of the lens.
Then the clip can be removed and
change the lens.To adjust the clip,
insert one side into the slot and then
push the other side into place.
•
These goggles must be replaced in case
of breakage, damage or be covered
with spatter as vision is lost on them.
6. OPERATING INSTRUCTIONS
Press 'Lens Test' button on the lens
before starting welding.
Before welding, the window will be in
light DIN 4 state and you can see the
work piece. The lens will automatically
darken when an arc is struck. Test the
lens by striking a lighter or match to test
the lens operation before striking an
arc on the work piece for the first time.
DO NOT USE IF LENS IS NOT OPERATING
PROPERLY.
6
Change dark shade between 9 and 13 as
desired by using the variable adjustment
knob.
Adjust the Sensitivity and Delay Time as
desired by using the variable adjustment
Knob.
Low
Battery
TEST
When helmet is not used for 15 minutes
the power will automatically shut-off.
There is no OFF switch.
To use the method of grinding work,
turn the sensitivity knob clockwise to
clockwise to the last position on the
right (Grind). To return to weld return
control to the desired level.

7. CARE AND MAINTENANCE

•
The filter lens should be cleaned when
the inner or outer cover lens were
replaced.
•
Wipe with clean dry cloth
•
Apply the ordinary disinfectant with
a clean cloth or paper towel. DO NOT
APPLY CLEANER DIRECTLY TO THE
FILTER LENS. DO NOT USE ALCOHOL