Maintenance & Cleaning - KRHÜNER 51299 Manual De Instrucciones

SELF-CLEANING
Note: Before you start the self-cleaning procedure, make sure the iron is not plugged in
and the steam control switch is in a no steam position.
1. Fill the water tank with water up to "MAX". Do not use vinegar or other descaling
liquids in the water tank.
2. Plug in and turn the temperature control switch to the "MAX" position. The power/
heating indicator lights / will turn on.
3. When the heating indicator light turns off, unplug.
4. Hold the iron in a horizontal position above the sink. Press and hold the self-clean
button.
5. Steam and boiling water will start to come out of the iron plate holes, which contain
salts and minerals that have been accumulated in the steam chamber from previous
uses.
6. Gently move the iron back and forth until the water tank is empty.
Caution: The water that comes out during self-cleaning is very hot. Be very careful not
to fall on you.
7. When the water tank is empty, release the self-clean button.
8. Allow the iron to cool down completely.
9. Wipe the soleplate with a cold damp cloth.
3. MAINTENANCE & CLEANING
• After using, lift the iron with the filling hole downwards to empty the remaining
water from the Water tank.
• Insert the plug into the socket, and set the temperature control knob to "MAX" for
1-2 minutes to evaporate the remaining water, and then unplug the iron and let it
cool down before storing it.
• Wipe off the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
• If the fiber is adhered to the soleplate, use a damp cloth with vinegar to wipe off
the soleplate.
• Never use strong acid or alkali in order to avoid damaging the soleplate.