Hortensus HOR-SFL10W Manual Del Propietário página 17

Installation
Drill 2 holes of
8 mm on the wall.
Wall Mounted
1. Prepare lamp, accessories and tools well firstly.
2. Use the allen wrench to loosen the bracket (see picture1), adjust it to the
appropriate angle(see picture2) and then fix the screw tightly(see picture3).
3. Use the allen wrench to loosen the light panel, pull it out and adjust to your
demanded lighting angle(see picture4), then fix the screws tightly (see picture5)
4. Fix the lamp onto the wall or lamp-post(see picture6).
Notice & Warning
1. This is a solar powered lamp, please install it in a location where can get
enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather.
3. The lamp will light up automatically at dusk.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage
protection.
5. The lamp is equipped with an internal battery pack, which is replaceable. If
any need, please contact seller for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new ones, please
toward the solar panel to sunshine or a strong light to activate the lamp.
7. Non-professionals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to avoid explosion.
It's workable for both
round lamp-post
(diameter
and square
lamp-post(side length
30-40mm)
Lamp-post Mounted
40-60mm)