TimeMoto TM-616 Guia De Inicio Rapido página 8

ENGLISH
This Quick Installation Guide contains the instructions for safe and correct
installation of the terminal.
Do not use the terminal if the power cable is damaged.
Do not use the terminal in humid environments.
Do not expose the terminal to direct sunlight or other heat sources.
1. Unpack the box and check the contents.
2. Mount the bracket to the wall.
Recommended mounting height (bottom of the bracket):
• 1.35 m (53.1 in) for the TM-616/TM626/TM818/TM828
• 1.20 - 1.40 m (47.2 - 55.1 in) for the TM-838
Make sure that the chosen location is in reach of your local
network (Wi-Fi or wired LAN).
When accessed through the wall (option A) and/or when
installing a TM-838 (option B or C): Feed the adapter cable
and LAN network cable (optional) through the bracket before
the next step.
3. Connect the power adapter and LAN network cable (optional) to
the terminal.
The LAN network cable is only required if you need to set up
a wired network connection instead of Wi-Fi.
Do not connect the adapter to the main power yet.
4. Place the terminal on the bracket.
5. Mount the terminal with two screws.
6. Connect the adapter to the main power. The terminal starts and
creates a temporary Wi-Fi hotspot for the setup of the terminal.
7. The welcome screen of the terminal shows 'SSID: TimeMoto-'
followed by a six-digit number.
8. Use a nearby computer or mobile device to connect to the Wi-Fi
hotspot named 'TimeMoto-' followed by the six-digit number of the
welcome screen.
Please be aware this will temporally change your network settings.
The settings will be restored to original state after installation.
9. Start a browser on the connected PC, laptop or mobile device.
Go to http://192.168.8.1.
10. Follow the on-screen instructions for the setup of the terminal.
During the setup you will be guided to the TimeMoto PC software
or TimeMoto Cloud.
The complete user instructions are found in a separate User Manual.
www.timemoto.com/manual
8