Publicidad
Idiomas disponibles
Idiomas disponibles
EN
310.04
Operating instruction
Fine boring heads
EWE 41-200 Digital
Important:
The digital display
always shows the
dimensional change to the previously set value
or to „0". The absolute value can not be shown.
Make dimensional corrections only with digital
display switched on and with the tool holder
assembled to the boring head.
Fig. 1
Preparation and presetting of the boring tool
Put the appropriate insert holder
head and tighten with clamp screws
the tool carrier by loosening the clamp screw
Adjust the desired diameter on a presetter by
the adjustment disc
. Lock the tool carrier with
clamp screw
.
Fig. 2
Carry out dimensional corrections
Switch on digital display by pressing button
The display
shows the previously stored value.
Press button
1s to reset the value to "0".
Loosen clamp screw
to unlock tool carrier.
Correct the dimension (difference between
actual and nominal diameter) by turning the
adjustment disc
. Lock tool carrier with clamp
screw
.
Fig. 3
When the battery level is too low, the tool display
will show the „Accu" message for a few
Fig. 1
BIG KAISER Precision Tooling Ltd. | Glattalstrasse 516 | CH-8153 Rümlang | T: +41 44 817 92 00 | info@ch.bigkaiser.com | www.bigkaiser.eu
seconds. This message indicates that the CR1025
battery must be replaced. The tool can still be
operational for a few hundred times more, but
we recommend replacing the battery as soon as
the "Accu" sign is shown for the first time.
Procedure for battery replacement:
Make the tool perfectly dry before replacing the
battery. If possible, apply some air pressure
around the edges of the battery lid
to the boring
remove any water trapped between the lid and
. Unlock
the main body. Remove the three screws
.
the battery lid, taking care to not let any water
drops fall inside the battery compartment or in
the lower side of the battery cover. Use a clean
cloth with alcohol to remove any oil or water
from the lower side of the battery lid
battery exchange please remove the old battery
and wait two minutes before placing the new one.
.
This will ensure a complete internal reset. Make
sure the O-ring is correctly placed before closing
the battery lid. Place the battery lid and tighten
the three screws.
General Information
- Max. coolant pressure: 40 bar (580 psi)
- Max. operating temperature: 40° C (104° F)
- Note that the tool carrier travel is limited.
Do NOT use force when adjusting.
- Periodic lubrication (every 20 operating
hours approx.) via the lube nipple ensures high
- Protection category DIN 40050: IP 69K
- Fine boring head can be connected with a
in order to
- Check the disclaimer in the app.
and
USA and Canada
The device complies with part 15 of the FCC
Rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions:
- This device may not cause harmful
. For
- This device must accept any interference
Changes or modifications not expressly approved
by the party responsible for compliance
could void the user's authority to operate the
equipment
Fig. 2
precision combined with long life. Light
machine oil is recommended, e.g. Mobil Vactra
Oil No. 2, BP Energol HLP-D32, Klueber
Isoflex PDP 94.
smartphone or a tablet. Download the app
"BIG KAISER" for iOS or Andorid devices in
the app stores.
interference, and
received, including interference that may
cause undesired operation.
Fig. 3
Publicidad
