Connection To The Mains - S&P COMET-N Manual De Instrucciones

DESCRIPTION OF THE APPLIANCE (FIGURE 1)
1. Drying temperature selector.
2. Shaver socket.
3. Connections cover.
4. Drying tube.
INSTALLATION (FIGURE 2)
• Carefully read the safety warnings listed above before installing the appliance.
• Drill two vertically aligned holes separated by a distance of 217 mm and insert the two wall
plugs provided. The bag of accessories also contains a small plastic support (A). Use one
of the screws provided to secure the support to the wall using the top hole.
• To access to the lower anchoring point you will need to remove the bottom cover (B) using
a small screwdriver. Slot the upper ridge of the appliance on to the plastic support (A) and
secure the entire unit to the wall using the other screw supplied.

CONNECTION TO THE MAINS

• Carefully read the safety warnings listed above before installing the appliance. Ensure that the
power is completely disconnected.
• Ensure that the mains cables have the required gauge for the power of the appliance (1,000W
/ 4.3 A). Class II appliances do not require and earth connection.
• The appliance is supplied equipped with a power cable for direct connection to a power point.
If you wish to connect the appliance directly to the mains, follow the steps
described below (Figure 3).
• To access to the connection terminals, you will need to remove connections cover (B) using
a small screwdriver.
• Disconnect the cables connected to the terminal block (Blue - Brown). Then remove the
fixing flange (C) and the power cable with the plug.
• Drill a hole in the bottom plastic cover in the area designed for cable entry (D). Insert the direct
mains connection cables through the bottom hole and connect them to the connection
terminal: L (brown) // N (blue).
• Replace the flange (C) and the connections cover.
7