Remote Control; Technical Characteristics - Ariston MOBIS 10 PLUS Manual Del Usuario

Remote Control

ON/OFF Turn the
device on and off.
MODE: three modes
available
AUTO
COOL
DRY
HEAT
FAN
Note:
Please do not select
the "HEAT" mode, because
this mode is not available.
FAN SPEED: Press
the "FAN" button to
adjust the fan speed
(the fan speed will
change each time you
press it).
Note:
Optional functions are
only available on some models,
so the model you purchased
may not have these functions.
SLEEP: Press the
"SLEEP" button to
let the air conditioner
operate at a low speed
(enabled/disabled);
"SLEEP" is used at
nighttime.
SWING: Press the "SWING" button
to enable and disable the swing of

Technical Characteristics

Power supply: 3.0 VDC (2xR03/LR03 dry battery)
Signal receiving distance: 8 m
Ambient temperature (Ta):-5°C < Ta < +60°C
Note: If this product does not contain a battery, you
need to purchase the type of battery as specified
above.
The manufacturer will not bear the responsibility for
personal injury or property loss caused by using an
improper battery.
Please operate the battery in accordance with the
operation instructions provided by the manufacturer.
the electric fan (optional).
SHORT CUT: Press the "SHORT
CUT" button to select and enable
your favorite settings (user-defined).
FOLLOW ME: Press the "FOLLOW
ME" button to enable and disable
the function with the same name.
TEMP : It is a temperature
adjustment (+) button. Each time the
button is pressed, the temperature
will increase by 1°C (up to 30°C at
the highest level).
TEMP : It is a temperature
adjustment (-) button. Each time the
button is pressed, the temperature
will decrease by 1°C (up to 17°C at
the lowest level).
Note:
To change the temperature
measurement unit from "°C" to "°F"
(and vice versa), please press two
arrows and hold for at least 3s.
TIMER ON: Press the "TIMER ON"
button to set the startup delay (each
time the button is pressed, the time
will increase).
TIMER OFF: Press the "TIMER
OFF" button to set the shutdown
delay (each time the button is
pressed, the time will increase).
LED display: Press the "LED" button
to disable and enable the LED display
on the air conditioner (optional).
CAUTION! Please observe the polarity
marked on the battery case.
182