EN
User Manual
4 USB-C™ multiport adapter
1
Safety instructions
The user manual is part of the product and contains important information for
correct use.
•
Read the user manual completely and carefully before use.
The user manual must be available for uncertainties and passing the product.
•
Keep this user manual.
•
Do not open the housing.
•
Do not modify product and accessories.
•
Do not short-circuit connectors and circuits.
Do not operate a device if it is not in working order. In such cases, it must be
secured against unintentional further use.
•
Use product, product parts and accessories only in perfect condition.
•
Avoid stresses such as heat and cold, moisture and direct sunlight, mic-
rowaves, vibrations and mechanical pressure.
•
In case of questions, defects, mechanical damage, trouble and other
problems, non-recoverable by the documentation, contact your dealer or
producer.
Not meant for children. The product is not a toy!
•
Secure packaging, small parts and insulation against accidental use.
•
Install the system and devices attached to it in a way that persons can-
not be injured, or objects not be damaged for example by dropping or
stumbling.
Heat storage
•
Do not cover the product.
•
Keep enough space around all devices for a good ventlation and free
motion and to avoid damages.
2
Description and function
2.1 Product
The product is an adapter that adds 4 USB-A connections to a device with a
USB-C™ connector.
2.2 Scope of delivery
4 USB-C™ multiport adapter, User Manual
2.3 Operating Elements
1 USB-C™ plug
2.4 Specifications
Item number
Connectors
Max. power
USB-A socket
Max. data transfer rate
Data reading & writing
speed
Operating conditions
Storage conditions
Dimensions
Cable length
Weight
3
Intended use
We do not permit using the device in other ways like described in
chapter "Description and Function" or in the "Safety Instructions".
Use the product only in dry interior rooms. Not attending to these
regulations and safety instructions might cause fatal accidents, injuries, and
damages to persons and property.
4
Preparation
1. Check the scope of delivery for completeness and integrity.
2. Compare the specifications of all used devices and ensure compatibility.
REV2022-09-14
V2.0aw
Subject to change without notice.
2 USB-A 3.0 socket
61073
66274
Input: USB-C™ plug
Outputs: 4x USB-A 3.0 socket
4.5 W @ 5.0 V
0.9 A max. per connector
5 Gbit/s
625 MB/s
0 °C ~ +45 °C | 10-85 % RH
-10 °C ~ +70 °C | 5-90 % RH
80 x 40 x 14.5 mm
17.5 cm
16 cm
37 g
35.2 g
5
Connection and operation
1. Connect your device (e.g. laptop) to the adapter via the USB-C™ plug.
2. Connect up to four devices to the USB-A sockets of the adapter using
suitable adapter or connection cables.
Connection cables are not included in the scope of delivery.
No software installation is necessary for operation. No elements need to be
operated during use.
Disconnecting and reconnecting the units can help to rectify faults.
Do not disconnect cable connections during data transmission to avoid pos-
sible data loss.
3. Disconnect all cable connections after use.
6
Maintenance, Care, Storage and Transportation
The product is maintenance-free.
NOTICE!
Material damage
•
Only use a dry and soft cloth for cleaning.
•
Do not use detergents or chemicals.
•
Store the product out the reach of children and in a dry and dust-protec-
ted ambience when not in use.
•
Store cool and dry.
•
Keep and use the original packaging for transport.
7
Disposal instructions
7.1 Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its compo-
nents must be recycled or disposed apart from each other. Otherwise
contaminative and hazardous substances can damage the health and
pollute the environment.
As a consumer, you are committed by law to dispose electrical and electronic
devices to the producer, the dealer, or public collecting points at the end of the
devices lifetime for free. Particulars are regulated in national right. The symbol
on the product, in the user manual, or at the packaging alludes to these terms.
With this kind of waste separation, application, and waste disposal of used
devices you achieve an important share to environmental protection.
WEEE No: 82898622
7.2 Packaging
Packaging can be disposed of free of charge at the suitable collection
points – paper belongs in paper bins, plastics belong in yellow sacks
and glass belongs in used glass bins.
DE4535302615620
8
EU Declaration of conformity
With the CE sign Goobay®, a registered trademark of the Wentronic
GmbH ensures, that the product is conformed to the basic European
standards and directives.
9
Symbols used
For indoor use only
Direct current
Recycling
- 2 -
61073, 66274
IEC 60417- 5957
IEC 60417- 5031
ISO 7001 - PI PF
066
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
Goobay®