Care & Maintenance - McLaren McS02 Manual Del Usuario

2. Handlebar grips assembly
Retract the handle grips from the steering lock.
Insert the handlebars into the T-section of the steering column. Use your finger to press
both buttons simultaneously until the handle grips can be inserted into the T-section.
Twist the handle grips until you hear the locking buttons click into position.
3. Handlebar adjusting
Unlock the clamp on the steering column by pushing the handle into the open position.
If the handlebars are not at the intended height, unlock the clamp again and twist it
round several times to ensure a tighter fit between the mounting brace and the steering
bar.
The handlebar can be locked at the desired height. Pull the handlebar stem from the
steering rod by pushing the locking button, until it is at the desired height and the button
has clicked into position.
Now close the clamp by
pushing the handle towards
the steering rod.
5
IMPORTANT: DO NOT FORGET TO FREQUENTLY TIGHTEN ALL MECHANISMS IN
ORDER NOT TO LOOSEN THE LOCKING PIN AND THE BOLT
Care/ Maintenance
Wheel bearings: avoid going through water, oil, or sand as this can damage wheel
bearings.
Cleaning: Clean the scooter with a soft cloth and a little water.
EN
6