Preparing For Installation; Assembly - eSmart GERMAY MIRALE Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Preparing for
installation
Mount this screen only on suitable surfaces. Pay
attention to the product specifi cations and if
necessary, hire a qualifi ed contractor to guaran-
tee the professional assembly of the screen.
Please keep the packaging in a good
1
condition, in case you wish to return the
screen.
Please be careful when
2
moving the unpacked
screen, especially when passing
through doors.
Select a suitable locati-
3
on for installation and
make that sure that the surface
is fl at and clean.
Mark the appropria-
4
te dimensions on the
wall for the drill holes of your
screen.

Assembly

From 180 inches and larger:
1
Connect the four halfed frame parts like
shown in the next picture by using the connec-
ting plates in order to get two long frame parts.
Slide the suspension bracket into the
2
upper tracks of the top frame sections.
Please note exactly the alignment of suspension
angle, as for the upper and lower frame part dif-
ferent suspension angle are included.
Slide the suspension bracket into the lo-
3
wer tracks of the bottom frame sections.
bottom frame section
Next, slide the mounting support into the
4
lower track of each frame component
and position these on the red arrows.
top frame section
17
E n g l i s h

Publicidad

Tabla de contenido
loading

Tabla de contenido