Manual Defrost; Cleaning, Care & Maintenance - Polar GE580 Manual De Instrucciones

UK
Operation
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The display
will flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
Fault
The appliance is not
working
Appliance is noisy or
works intermittently
Cooler cabinet is not
cold enough
Condensation
4
GE580-GE581_ML_A5_v1_20200724.indb 4 GE580-GE581_ML_A5_v1_20200724.indb 4
buttons to display the
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Appliance is not level
The appliance is touching a
neighbouring object
Temperature set incorrectly
External environment may require
colder temperature
The door is opened too often
Door seal is worn
Condensation may occur when the humidity is high and water particles in the
air contact with cold surfaces. This is normal, just wipe away with a dry cloth

Manual Defrost

• The appliance will automatically run a defrost
cycle every 4 hours.
• To manually defrost the appliance: Press and
hold the defrost button "
to begin a manual defrost. The defrost light
illuminates.
Cleaning, Care &
Maintenance
• Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
• If left unused for any length of time, store the
appliance with the door ajar.
Troubleshooting
If your POLAR appliance develops a fault, please
check the following table before making a call to
the Helpline or your POLAR dealer.
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
Check installation position and change if
necessary
Check installation position and change if
necessary
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Call POLAR agent or qualified technician
" for 2 seconds
2020/7/24 16:21 2020/7/24 16:21