Uline H-6304MAH Manual De Instrucciones página 2

4. To hang files from side to side, attach one bar
clip (C) to each side of drawer and insert one
long metal bar (D). (See Figure 3)
Figure 3
D
C
File cabinet may be mounted under a desk or
credenza shell.
1. Open top drawer and locate plastic tab on drawer
slides. Push up on one tab and push down on
opposite tab to release drawer and remove.
2. Locate cam locks inside the cabinet near the top
panel. Using Phillips screwdriver, turn cam locks 1/4
to the left to unlock and then remove the top panel
from the cabinet.
PAGE 2 OF 6
ASSEMBLY CONTINUED
5. To hang files from front to back, attach two bar
Figure 4
UNDER DESK MOUNTING
3. Place file cabinet underneath desk or credenza
1-800-295-5510
uline.com
clips (C) to back of drawer and insert two short
metal bars (E). (See Figure 4)
E
C
shell and align support bars with holes in desk or
credenza shell. Insert M6 x 40 mm screws (F) and
tighten using Phillips screwdriver.
NOTE: To attach cabinet to left side of a desk
or credenza, use four holes on left side of
cabinet. To attach cabinet to right side of a
desk or credenza, use four holes on right side
of cabinet.
1021 IH-6304MAH