Blumfeldt Sommerfest Manual De Instrucciones página 12

EN
12
ASSEMBLY
Choose a flat surface for the tent. Unpack all parts from the carton and
check that the parts are complete (see list). Lay the parts on the floor as
shown in the drawing to assemble them. Connect the corner connectors (4)
and the middle connectors (5) to the rods (2) for the roof. Repeat this step
for the sides. Then connect the rods (1) with the assembled side parts (2,4,5).
The rods must be fixed with the knurled screws.
Jack up one side and insert the leg tubes (3) into the corner connectors (4)
and middle connectors (5).
1
2