Bosch Air 4000 Instrucciones De Instalación página 48

Moving and storage
▶ Long press the filter button
interface will show the message of filter status100%.
Fig. 60 Filter lifetime reaching 100%
The filter status is constantly displayed on the top left hand side of the
digital display.
6 Moving and storage
Moving
• Use two hands to hold the appliance when moving it.
Storage
▶ Turn off the air purifier and unplug it from the power socket.
▶ Clean the air purifier, the particle sensor and the surface of the filter
( Chapter 5 "Cleaning and maintenance", Page 46).
▶ Let all parts airdry before storing.
▶ Wrap the filter in air-tight plastic covers.
▶ Store the air purifier and the filter in a cool, dry location.
▶ Wash your hands after handling the filter.
7 Troubleshooting
This chapter summarizes the most common issues that may occur with
the appliance. If the solution is not found in the table below, please
contact an authorized service technician.
48
to reset the filter lifetime counter. The
0010043375-001
Problem
The airflow that comes out of
the air outlet is significantly
weaker than before.
The air quality does not
improve, even though the
appliance has been operating
for a long time.
The color of the air quality
light always stays the same.
The appliance produces a
strange smell.
The appliance is very loud.
Table 15 Problems and solutions
Possible solution
The surface of the filter is dirty. Clean
the surface of the filter ( Chapter 5
"Cleaning and maintenance", Page 46).
• Check if the plastic cover is removed
from the filter.
• The filter has not been placed in the
appliance. Make sure that the filter is
properly installed.
• The particle sensor is wet. The
humidity level in the room is high and
causes condensation. Make sure
that the particle sensor is clean and
dry ( Chapter 5 "Cleaning and
maintenance", Page 46).
• Room size is large or the outdoor air
quality is poor. For optimum
purification performance, close the
doors and windows when operating
the air purifier.
• There are indoor pollutants. For
example, smoking, cooking,
incense, perfume or alcohol.
• Filter has reached the end of life.
Replace the filter with a new one.
The particle sensor is dirty. Clean the
particle sensor ( Chapter 5 "Cleaning
and maintenance", Page 46). If the air
quality is good, the light should be blue
at all times.
The first few times using the appliance,
it may produce a plastic smell. This is
normal. However, if the appliance
produces a burnt smell even after
removing the filter, contact support
services.The filter may produce smell
after being used for a while because of
the absorption of indoor gases. It is
recommended to reactivate the carbon
filter by putting it in direct sunlight. If
the smell persists, replace the filter.
• The appliance is operating at a high
speed, as set in manual mode.
• In Auto mode, if the appliance is too
loud, it may be operating at high
speed, because poor air quality has
been detected. Switch to lower fan
speed.
• If there is an unusual sound, contact
support services.
• If anything drops into the air outlet, it
may also cause an unusual loud
sound. Immediately switch off the
appliance, turn the appliance upside
down, to get foreign objects out of
the appliance.
Air 4000 – 6721848798 (2022/11)