EGO PH1420E Manual De Instrucciones página 7

DESCRIPTION
KNOW YOUR POWER HEAD (Fig. A)
1. Air Outlet
2. Air Inlet
3. Rear Handle
4. High/Low-Speed Switch
5. Speed Indicator
6. Shoulder-Strap Mount Hanger
7. Quick-Adjust Front Handle
8. Power-Head Shaft
9. Shaft-Release Button
10. Wing Knob
11. Coupler
12. Threshold Ring
13. Lock-off Lever
14. Variable Speed Trigger
15. Rubber Pad
16. Battery-Release Button
17. Latch
18. Electric Contacts
19. Ejection Mechanism
20. Shoulder Strap (special accessory)
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Always remove the battery pack from
the product when you are assembling parts, making
adjustments, cleaning, or when the product is not in use.
INSTALLING A POWER HEAD ATTACHMENT
WARNING:
Read and understand entire Operator's
Manual for each optional attachment used on this power
head and follow all warnings and instructions. Failure to
follow all instruc tions could result in electric shock, fire
and/or serious personal injury.
WARNING:
This 56V power head PH1420E is
designed to be used only with the EGO attachment
models that are specified in this Operator's Manual or
subsequently introduced by EGO for use with this power
head. Use of other, unauthorized attachments could cause
serious personal injuries or property damage.
WARNING:
Never install, remove, or adjust any
attachment while the power head is running or with
the battery installed. Failure to stop the motor and
remove the battery can cause serious personal injury.
NEVER OPERATE THE POWER HEAD WITHOUT AN
ATTACHMENT.
The attachment connects to the power head by means of
a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Remove the end cap from the attachment. Align the
arrow on the attachment shaft with the arrow on
the coupler and push the attachment shaft into the
coupler until you hear a clear "click" sound, which
indicates that the attachment shaft is mounted into
place (Fig. B).
Fig. B parts description see below:
B-1 Attachment Shaft
Arrow on the
B-2
Attachment Shaft
B-3 Wing Knob
4. Pull the shaft of the attachment to verify it is securely
locked into the coupler. If not, rotate the attachment shaft
from side to side in the coupler until it snaps into place.
5. Tighten the wing knob securely.
WARNING:
Be certain the wing knob is fully
tightened before operating equipment; check it
periodically for tightness during use to avoid serious
personal injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Press the shaft-release button, with the button
depressed, pull or twist the attachment shift out of
the coupler.
MOUNTING AND ADJUSTING THE QUICK-ADJUST
FRONT HANDLE
1. Stop the motor and remove the battery pack, if installed.
2. Loosen the wing nut to separate the front handle (Fig. C).
Fig. C parts description see below:
56 VOLT MULTI TOOL POWER HEAD — PH1420E
B-4 Arrow on the Coupler
Shaft-Release
B-5
Button
B-6 Power-head Shaft
7
EN