Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Wiring Configuration
GOLD-Series subwoofers are made with
dual 4Ω voice coils. Both coils must be
connected to a source of amplification.
They will provide a 2Ω load wired in parallel
or 8Ω load wired in series. Make sure
your source unit or amplifier is rated
at the correct ohm load for operation.
The speaker wire should be kept away
from sharp edges and avoid the possibility
of getting pinched by the trunk. If a factory
hole and grommet do not exist or are
inaccessible, you must drill a hole through
which to run the wire. Be careful not to drill
into other wiring or existing mechanisms.
Any time a wire is run through a hole, it
is necessary to insert a rubber or plastic
grommet to protect the wire from damage.
English
5
Publicidad
