Publicidad
Idiomas disponibles
Idiomas disponibles
3. Load a single log lengthwise onto the log rail. Always split
along the grain of the wood and not against.
NOTE: Do not exceed the maximum log diameter of 10 in.
(25.4 cm) or the maximum log length of 20.5 in. (52 cm).
m
WARNING!
Never load or unload logs while the log
pusher is moving.
4. To start splitting, push the power button with your
right hand and pull the control lever with your left hand
simultaneously (Fig. 6).
NOTE: Knots, green woods or hard woods may present
additional resistance for the log splitter. Do not force the
machine if the log does not split on the first attempt.
Control
lever
Power
button
5. The log pusher will move forward and force the log into
the splitting wedge.
6. Release both the power button and the control lever.
Wait until the log pusher has completely returned to its
original position and stopped moving before removing any
material.
7. To split a log further, place the piece of wood onto the log
rail and repeat steps 4 - 6.
Removing a Jammed Log
If a log becomes stuck on the splitting wedge and will not
completely split, follow the directions below to remove the log.
m
WARNING!
Do not attempt to remove the jammed log
with your hands or knock it out of the splitting wedge. This
may cause serious injury or damage to the machine.
1. Release both the power button and the control lever. Wait
until the log pusher has completely returned to its original
position and stopped moving.
2. Insert a wooden wedge under the jammed log (Fig. 7).
Fig. 7
3. Push the power button and pull the control lever
simultaneously to start the log splitter. Allow it to push the
wooden wedge completely under the jammed log.
4. Repeat steps 2 - 3 using progressively larger wedges until
the jammed log is free.
Care + Maintenance
m
WARNING!
built-up pressure has dissipated before inspecting, cleaning, or
performing any other maintenance task.
m
WARNING!
work described in this manual. Any other work must be
Fig. 6
performed by a qualified technician.
• Periodically apply a light coat of rust-resistant oil, such as
3-in-1 oil or WD-40, to the springs to keep them in proper
working order.
• Periodically check for any loose fasteners or worn,
missing or damaged parts.
• Periodically clean and lubricate parts.
• Sharpen the splitting wedge as needed. Use a flat file or
angle grinder, take off burrs and smooth rough sections of
the cutting edge.
Replacing the Hydraulic Oil
After every 150 hours of use, the hydraulic oil needs to be
replaced with AW32 anti-wear hydraulic oil. To replace the
hydraulic oil, follow the instructions below.
1. Make sure all moving parts have come to a complete stop
before removing the batteries from the log splitter.
9
Wooden
wedge
Jammed log
Always remove the batteries and ensure all
Only perform the repairs and maintenance
Publicidad
