Safety During Operation; Preparing For Use; Use; Switching On And Adjusting Air Flow - Wella Professionals SAHIRA anti-static Manual De Instrucciones

Sahira anti.book Seite 21 Donnerstag, 24. November 2011 6:31 18

Safety during operation

DANGER:
• Do not direct the air flow towards eyes, hands or
other areas sensitive to heat.
• Danger of burns! Do not touch the hot surfaces of the appli-
ance.
• Lay the cord in such a way that nobody can trip over or
tread on it.
• If a problem occurs during use, pull out the mains plug
immediately and send the appliance to the Technical Cus-
tomer Service.
• Always use the original styling nozzle only.
• For technical reasons no attachments must be used with
the Sahira anti-static that are pushed onto and fastened to
the outside of the appliance.
Cleaning and storage
DANGER:
• Risks also exist even when the appliance is
switched off. Disconnect the hand hair dryer
from the mains each time after operation, and
also before cleaning.
• Let the hand hair dryer cool down before you store it.
• Never use pointed objects (e.g. the tail of a comb) to
remove dust or foreign bodies from inside the appliance.
There is a risk of electric shock.
• Do not use aggressive or abrasive cleaning products to
clean the appliance.
• Do not wind the cord round the appliance (risk of damaging
the cable).

3 Preparing for use

• Carefully unpack the Sahira anti-static and the styling noz-
zle supplied.
• Check the appliance and cord for any damage. Do not use
the appliance if it is damaged.
• Before connecting the Sahira anti-static to
the mains, make sure that the mains
voltage corresponds to the voltage
specified on the rating plate 2. You will
Rating
find the rating plate below the air inlet
plate
opening.

4 Use

4.1 Switching on and adjusting air flow

Use switch 5 to switch on the Sahira anti-
static and select the desired air flow speed:
0 = Off
1 = Slow, air flow low
2 = Fast, air flow high
5
21