Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Always wear eye, hearing, hand protection to
reduce the risk of injury when operating the tool.
Keep all parts of your body away from the
rotating wheel.
WARNING:
Sparks generated when grinding metal. Take
care that no combustible materials presented in
working area.
SWITCHING ON/OFF
WARNING:
Only start the tool when its wheel is not
contacting with workpiece.
1. Turn the on/off switch to "1". The tool will accelerate
gradually until it reaches a full speed.
2. Turn the on/off switch to "0". The tool will slow down until
it comes to a complete stop.
GENERAL OPERATION
1. Test the machine for a minute at the maximum speed
before applying to workpieces.
2. Abandon accessories suffered from a drop before. Out-
of-balance or damaged accessories can mar workpiece,
damage the tool, and cause stress that may cause
accessory failure.
3. Always guide the grinder with both hands. Grip the
main handle with one hand and another on the auxiliary
handle.
4. Use cutting wheel for cutting and use grinding wheel for
grinding.
5. Fit a proper guard for the purpose of cutting or grinding
to provide maximum protection. Use unsuitable guard
during operation will cause serious injury.
6. Secure workpiece in a vise or clamp to a workbench to
ensure a safe operation.
7. Allow accessories to come to full speed before start.
8. Properly apply the pressure and control the contact
between accessory and workpiece.
9. Lift the grinder away from the workpiece before turning
off the grinder.
10. Turn off the tool and make sure it comes to a complete
stop before laying it down.
WWW.SENIXTOOLS.COM
OPERATION
GRINDING
1. Fit a grinding wheel and a guard for grinding
recommended by the manufacturer.
2. Position the tool at an angel of 15° to 30° for a best
working results.
3. Do not over force the tool. Sightly and evenly press
down and lead the machine forward or backward.
CUTTING
1. Replace a cutting wheel and a wheel guard for cutting
recommended by manufacturer.
2. Insert the cutting wheel vertically into the surface of
objects.
3. Do not give any lateral pressure to the wheel or sway
from side to side.
4. Begin cutting with minimum cross-sections.
5. Only work against the run of the wheel.
6. When the wheel become very hot and sparks flash
around,stop cutting and cool down at no-load speed for
several minutes.
HOW TO CHARGE THE BATTERY
PACK
��°~��°
WARNING:
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
17 - EN
Publicidad
