Publicidad
Idiomas disponibles
Idiomas disponibles
Positioning Arm in Channel
WARNING: Do not attempt to remove the Arm from the
channel while device is mounted.
1. Loosen the set screws in the Slide.
2. To raise or lower the Arm in the channel, relieve the weight of the
mounted device by lifting the underside of the Arm, near the device.
Simultaneously, push up or pull down the opposite end of the Arm
immediately in front of the Slide.
Cable Management
Two cable management features allow placement and flow of cables:
1. An open cavity beneath the arm with flexible cable covers
manages cables going between front and rear of the arm.
2. A "pass-through" channel slide allows cables to run behind the
arm within the Channel. Note: If cable connectors are too large
to fit through the pass-through, try placing the cables in the
path of the Slide before installing the arm in the Channel.
Contact GCX for optional Channel Covers available to further
manage the flow of cables in the Channel.
Attachment of Down Post
Some applications may require a Down Post to mount module racks
or other devices. Attach Down Post as follows:
1. Align the screw holes in the Post with corresponding threaded
holes in the Swivel Fitting.
2. Using the 5/32'' [4 mm] hex wrench provided, fasten Down Post to
Swivel Fitting with three (3) #10-32 x 3/8" SHCS.
Routine Maintenance
Periodically inspect all hardware associated with the mounting system. Tighten as required for optimal operation and
safety.
Cleaning the Mounting Assembly
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Do not use Steel wool or other abrasive material.
4. Damage caused by the use of unapproved substances or processes will not be warranted. We recommend testing of
any cleaning solution on a small area of the arm that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the arm. Wipe any cleaning agents off of the arm immediately using a water-
dampened cloth. Dry the arm thoroughly after cleaning.
CAUTION: GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital's infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
Flexible Cable Covers
Swivel Fitting
10-32 x 3/8" SHCS (3)
DU-WMM-0001-I-20 Rev A 1/09/09 GCX Corp. Page 3 of 3
Set Screws (2)
Pass-through Slide
Post
Publicidad
