Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Attach the Connect Beam (D) to the Left Side Frame (A)
and Right Side Frame (B), using the 1/4"x 13mm Bolt
(AA), tighten with Allen Wrench (EE).
Hardware Used
AA
1/4"x 13mm Bolt
EE
Allen Wrench
2. Attach the Metal Bar (C) to the Left Side Frame (A) and
Right Side Frame (B), using the 1/4"x 13mm Bolt (AA),
1/4"x 10mm Bolt (CC), and 1/4" Nut (DD), tighten with Allen
Wrench (EE) and Open Wrench (FF).
NOTE: DO NOT fully tighten all bolts until you finish assem-
bling all parts. Once assembled, go back and fully tighten
all bolts. This will make the assembly easier.
Hardware Used
1/4" x10mm Bolt
AA
1/4"x 13mm Bolt
x 4
CC
DD
1/4" Nut
x 1
EE
Allen Wrench
x 1
FF
Open Wrench
3. Attach the Panel Shelf (E) to the Left Side Frame (A)
and Right Side Frame (B) and Connect Beam (D), using the
M4 x 32mm Screw (BB).
Hardware Used
BB
M4 x 32mm Screw
1
A
D
B
x 12
x 1
AA
EE
2
EE
CC
AA
FF
DD
x 1
x 1
B
A
3
A
E
B
x 15
5
ASSEMBLY INSTRUCTIONS
4. NOTE: The tipping restraint hardware included is for
wooden stud wall construction. It must be attached to a
wall stud. Depending upon your wall construction, differ-
ent anchor hardware maybe required. Please contact your
local hardware store for assistance. Young children can be
seriously injured by tipping furniture. You must install the
tipping restraint hardware with the unit to prevent the unit
from tipping, causing any accidents or damage. The tip-
ping restraints are intended only as a deterrent, they are
not a substitute for proper adult supervision. The tipping
restraints are not earthquake restraints. If you wish to add
the extra security of earthquake restraints, they must be
purchased and installed separately.
Hardware Used
Tipping Restraint
GG
Hardware
C
BB
D
Wooden stud
4
GG
Connector
Wall
Metal bracket
1set
Steel cable
6
Short screw
Long screw
Publicidad
