camry Premium CR 4415 Manual De Uso página 4

17. To provide additional protection, it is advisable to install a residual
current device (RCD) in the electric circuit with a rated residual current not
exceeding 30 mA. Ask an electrician for this advice.
18. Never use the device without water! It may be damaged.
19. Never use the device with sparkling water !!!
20. Never leave the device at a temperature below 0 degrees Celsius, as it
may damage it.
21. Always unplug the machine before filling the tank with water.
22. Regularly clean and inspect the machine to ensure the quality of coffee
obtained and to extend the life of the machine.
23. Always disconnect the power source before cleaning and allow all hot
parts to cool down. The device should be cleaned with a mild non-abrasive
detergent. Never use cleaning solvent as this could damage the paint
layer.
24. For descaling the machine, use a liquid descaler designed for pressure
coffee makers.
25. Use only original accessories.
26. Do not move or move the device during operation.
Device description Moka maker:
A. Lid B. Top tank C. Bottom tank
indicator H. Safety Valve
filter L. Upper Disk Filter
Preparing the device for use.
1. Remove all packing material from the device.
2. Rinse the inside of the Top tank (B) and Bottom tank (C) with water making sure the water does not overflow.
3. Use a dry paper towel to dry the device both inside and outside making sure the area between the Base (D) and the Bottom tank (C )
is dry.
Please note this device is for making coffee. Do not use any other extracts, cocoa powder, herbs, flowers, sugars, infusions soluble
substances, or other substances that might block the holes in the device filters.
Never immerse the base and the boiler in the water while cleaning.
Using the device:
1. Check if the device is not hot from previous use.
2. Grasp the Top tank (B) with a dry hand and do not press or pull on the handle.
3. Grasp the Bottom tank (C ) with your other hand.
4. Twist the Top tank (B) counterclockwise until you unscrew the Top tank (B) from the Bottom tank (C ) making sure not to press or pull
on the handle.
5. Once you open the device take out the Disk Filter (J) and the Funnel filter (I).
6. Fill the Bottom tank (C ) with water. The water level should not reach the Safety Valve (H).
7. Insert the Funnel filter (I) into the bottom tank.
8. Fill the Funnel filter (I) with ground coffee to around 4/5 of its capacity.
9. Put the Disk Filter (J) with the little button facing upward. The Disk filter is designed to keep the coffee ground in the Funnel filter. If not
used small parts of the coffee ground can end up in the finished coffee brew.
10. Screw the Top tank (B) back on top of the Bottom tank (C). Make sure not to press or pull on the handle.
11. Put the assembled device onto the Base (D).
12. Press the ON / OFF button (F). The Light indicator (G) will turn on.
13. The Moka maker will start brewing.
14. After some time the Moka maker will start to bubble and prepare the coffee.
D. Base E. Power cord
I. Funnel filter
4
F. On / Off switch
J. Disc Filter K. Gasket for upper disk
G. Light