Publicidad
Idiomas disponibles
Idiomas disponibles
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The device must be completely removed from its packaging. All guards must be completely removed.
Place the appliance on a solid, flat surface Never put the electric waffle maker on a flammable surface.
Do not install this device near open fires or other heating devices.
The electrical cable must be protected to at least 16 Amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
Press the switch to turn on the waffle maker.
Heat the unit for 20 minutes until all the smoke and smell are dissipated.
NEVER use cold water on the cast iron plates as you risk causing thermal shock.
USE
Connect the device, press the switch, the red light comes on.
Turn the temperature adjustment knob. The temperature can be between 60° and 300°C.
We recommend that you use this device at a maximum temperature of 220°C.
Once the desired temperature is reached, the red light goes out.
Pour the waffle batter in the center of the plate. Close the appliance and cook for the recommended
cooking time using the timer.
When the temperature decreases, the device starts heating again and the red light turns on again.
At the end of use, turn the thermostat to 0 and press the switch to OFF mode.
TIMER
Count up: stopwatch
Count down: timer
'-' and '+': timer setting
Stopwatch
Start press '+' for stopwatch. To stop, press '+' .
5 beeps to signal stopwatch stoppage.
timer
Pressing '–' and '+' simultaneously displays the default value: 10sec.
Simultaneously press '-' and '+' again (2 beeps).
EN
Publicidad
