Casselin CG180S Manual De Instrucciones página 15

timer
Pressing '–' and '+' simultaneously displays the default value: 10sec.
Simultaneously press '-' and '+' again (2 beeps).
The time flashes, you can set the desired time with '–' and '+' (0.1 - 19.59 min).
Wait for the screen to turn off then press '-' to start the timer.
5 beeps to signal the end of the timer.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
6. CLEANING AND MAINTENANCE
6.1 Safety instructions
Any maintenance, cleaning, repair of the appliance must be done with the appliance unplugged (isolated from
all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the appliance in water or any other liquid.
Use the Casselin brand products provided for this purpose.
WARNING
The device cannot be cleaned with a direct water jet (no pressurized water jet).
6.2 Daily maintenance
Unplug the device
Clean the device with warm water and a clean cloth after each use.
After cleaning, use a soft, dry cloth to polish and dry the device. All parts must be dried.
Store the device in a dry place.
6.3 Safety instructions for the maintenance of the device
Daily check that the power cord is not damaged. Never use the appliance when the cord is damaged. If the
cord has any faults, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair work should only be carried out by a professional.
REMARK
In the event of a trip, unplug the appliance, let it cool down and contact your retailer. If the unit does not start,
check your power cord. The device must not be plugged into a power strip but directly into a wall socket. For
any other anomaly, contact your dealer.
REMARK
Waste from used appliances: all used appliances must, when disposed of, comply with the regulations in
force in their country*. It is imperative to make the device unusable before disposal by removing the power
supply cable.
* in terms of ecology and recycling
EN