MARTINS Industries Impulse MX-P1 Manual página 4

SAFETY
• Wear approved safety glasses and ear protection.
• Use only impact rated sockets.
• Do not use power tools in explosive environment (in the presence of flammable liquids, gases or dust).
• Avoid contact with grounded objects such as pipes, radiators, stoves and refrigerators to prevent the risk of electric shocks.
• Do not expose power tools to rain or wet conditions to prevent the risk of electric shocks.
• Attach long hairs and do not wear loose clothes while using power tools, to avoid the risk getting caught in moving parts
• Do not use another battery charger than the one provided.
• In bad conditions, liquid may be ejected from the battery; avoid any contact! In case of accidental contact, flush with water.
If the fluid comes in contact with eyes, seek medical assistance. The ejected fluid may cause irritation or burns.
OPERATIONS
1- Connect the impact rated socket on the anvil
2- Control the rotation direction using the controls on the tool
3- Control the speed using the controls on the tool
4- Place the socket on the nut and pull the trigger to operate the tool. The speed depends on the speed setting and on the
pressure that is applied on the trigger.
FORWARD (CLOCKWISE) OPERATION
The motor has an electronic clutch with 3 forward speed settings (low, medium, high).
The speed is adjusted by pushing the button on the control panel on the base of the tool. The trigger needs to be momentarily
pushed to activate the speed settings.
REVERSE (COUNTERCLOCKWISE) OPERATION
The electronic clutch has 2 different reverse modes: Full Reverse and Auto Break
Full Reverse mode is automatically activated when the rotation switch is put to reverse position. No LED on the control panel
should be illuminated.
When the trigger is pushed the tool will operate in reverse as long as you hold the trigger.
Auto Break mode is engaged by pressing the control panel button while the rotation switch is in reverse position. A red LED light
will be visible on the control panel when activated.
When the trigger is pulled the tool will start hammering in reverse. As soon as the bolt breaks loose and there is no resistance the
tool will stop reverse motion. To disengage the Auto Break mode simply press the control panel button again.
Note: Both reverse functions only operate with the electronic clutch in the third speed position.
BEFORE using this product, read this manual and follow all its Safety and Operating instructions.
Failure to do so may result in personal injury and/or property damage.
Retain these instructions for future reference.