Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instruction
AtA Signal Converter 2
EN
General safety notes extra low voltage products <50VAC/<120VDC
1.
Failure to follow warnings and installation instructions can cause serious personal injury or
damage the installation.
2.
Installation must be in accordance with latest electrical regulations and national
requirements.
3.
Turn off electrical power before installing or servicing the product in any way.
4.
Broken or damaged products must be removed immediately.
5.
The person responsible for any modification to the product shall be considered the
manufacturer.
6.
HATO bears no liability for damage caused by inappropriate use or application.
7.
To reduce the risk of fire and overheating, make sure all connections are made according to
standard regulations and installation instructions.
8.
To reduce the risk of fire and burns do not install this product where the exposed bare
conductor can contact any conductive material.
9.
Do not install any product closer than 15 cm from any curtain or similar combustible
materials or a heat source.
10. To minimize the risk of electrical interference, install the power cables separate from the
dimming signal cables. Especially keep cables switching heavy (inductive) loads away
from signal cables. In case both cables have to cross each other, do this perpendicular to
minimize interference.
11. Install the product in an enclosure suitable for its environment.
12. This is a extra low voltage product, do not directly connect to a different higher voltage.
13. In case of discrepancy, the English version shall prevail.
HATO BV
Handelsstraat 31, NL - 6135KK Sittard
Read and follow all instructions
www.hato.lighting
info@hato.lighting
Publicidad
