Lionelo Thermup 2.0 Manual De Usuario página 10

Food warming function
1.
Place the food container in the heater (fig. 6).
2.
Fill the heater with 80 ml of distilled water (fig. 7).
3.
In the display, select the Food heating function (fig. 8). Wait until the indicator light comes on.
4. Select the temperature using the increase and decrease buttons of the selected value
(2.3, fig. B). The temperature range for this function is 45 - 80°C. The display shows the
current food temperature.
NOTE
Due to the high variety of textures of baby food, frequent mixing and controlling the temperature
of the food is recommended (fig. 9).
Always check the temperature of the food before feeding (fig. 10).
Sterilization function
Wash and thoroughly rinse the bottle and accessories before disinfection.
1.
Place the item to be sterilized in the heater (fig. 11). The bottle should be placed bottom up.
2.
Fill the heater with 30 ml of distilled water (fig. 12).
3.
In the display, select the Sterilize disinfection function (fig. 13). Wait until the indicator
light comes on.
Once the water has evaporated, the device switches off automatically. The disinfection time is
approximately 10 minutes.
Temperature range and operating time of selected modes
Note! If there is no water in the reservoir, the device will switch off automatically.
Mode
Milk
Food
Sterilize
Fast
Cleaning
1.
Unplug the device after each use and before cleaning. Allow the device to cool down
before cleaning (fig. 14).
2.
Empty the device of water (fig. 15).
EN
Temperature range
37 - 60°C
45 - 80°C
100°C
100°C
‑ 10 ‑
Operating time
Up to 24 hours
Up to 24 hours
Up to 10 min
3-8 min