Publicidad
Idiomas disponibles
Idiomas disponibles
50
4
Configuration of basic settings
Via (CONF) you will get to the menu item "Configuration" and then on to submenu item "General".
The entire structure of the menu (CONF) is displayed graphically for each meter.
Lab 745 see 8.4, Lab 845 see 9.4, Lab 945 see 10.4
Under "General", the following device-relevant basic settings can be configured:
Display
Password
Clock
Reset
Language
Time OFF
Response action
4.1
Configuration of the backlight and the contrast
The backlight of the display can be switched on or off on the meter.
Configuration of the lighting:
"General" > "Display"
Configuration of contrast:
"General" > "Display"
Via (CONF +1) or (LOG -1) you selected the desired setting.
(ON/OFF) confirms and saves your setting.
(MEAS) terminates the entry dialog without transferring the value.
4.2
Configuration of the password
The menu items calibration (CAL) and configure (CONF) can be protected by a password.
The password to open the individual menus is deactivated when the device is delivered!
Password = 0 (status at time of delivery)
Password > 0 (password inquiry is active, the user is asked for a password)
The password can have up to 4 digits (1 - 9999).
Password configuration:
(CONF) > "General" > "Password"
Via (INFO) or (CAL) you select the position to change.
Via (CONF +1) or (LOG -1) you change the position.
(ON/OFF) confirms and saves your setting.
(MEAS) terminates the entry dialog without transferring the value.
backlight and contrast
Password
Clock
Restart device
Language
Time until automatic switch-off
Filtering the measured value
"Backlight", then select activate / deactivate.
>
"Contrast", then select low - medium - high.
>
enter and repeat password.
>
Publicidad
