HOMCOM 830-597V80 Manual De Instrucciones página 2

Before You Start
●Screw the pole into the tree base, decide on an appropriate location for your product.
● If you have any doubt about installing this product,consult a qulified electrician.
Installation and Instruction
1.This tree light is sulitable for INDOOR USE.
2.The daptor MUST be installed INDOORS away from weather.
3.Do not position or place near heaters or any other direct sources of heat.
4.This product is suitable for positioning on surfaces which have normal flammability. eg.
wood, plasterboard,masonry. However, this does not include highly flammable surfaces (e.g.
polystyrene, textiles).
5.Always position cables and extension leads so that they will not be a hazard to the eldenty,
pets and children.
6.DO NOT position this set where it may become covered by other items e.g. curtains, nets or
bedding.
7.Ensure the unit(s) is positioned so that you have enough cable to reach an indoor mains
power socket.
Warning
Do not try to remove these non-replaceable bulbs.
This product is NOT designed for permanent or long term use.
The supplied adaptor is suitable for operation of LED Modules only.
Only operate this light set with the supplied adaptor.
Do not connect this twig tree elecrically to another twig tree.
Do not connect this twig tree to the power supply while it is in the packaging.
If any part of light set or cable is damaged, the light set MUST be discarded.
This product is for use as a decoration only. Not to be used by children as a toy. Keep out of
reach of children.
Always switch off this light set or unplug an adaptor if unattended.
DO NOT overload power sockets or extension leads.
DO NOT pierce the cable when securing in place, bend or stand on the twig tee, as this will
damage the bulbs or wiring.
Please refer to the packing or product rating label for product class, specifications and rating.
LED Bulbs
This light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of
the bulbs in the light set.
Shaping the Tree Branches
The branches need to be expanded manually and take some time to get the final effect of the
picture
1