Publicidad
Idiomas disponibles
Idiomas disponibles
Page 10
Section 5. Troubleshooting
SYMPTOM
Plastic lid is
cloudy
Reduced
Flow / Low
Chlorine /
Flow Indicator
Not Moving
Leaks around
connections
or cover
Low chlorine
concentration
in the pool
Water is green
and/or algae
is present
ENGLISH
CAUSE
Chlorine exposure
Clogged chlorinator
body
Damaged o-rings
1. The trichlor tabs
have been consumed
2. Filtration time too
low
3. Chlorine demand
too high
A water parameter
is not properly
maintained (pH,
cyanuric acid, etc)
TF Tablet Feeder | Installation & Operation Manual
Polaris
AutoClear
®
™
CORRECTIVE ACTION
Remove the lid and wipe clean. Place
lid in an open area, some cloudiness
may clear itself if left exposed to
sunlight and fresh air.
If cover becomes opaque and does
not clear after steps above, the cover
should be replaced.
DO NOT leave chlorinator open
without the lid installed. If the lid must
be left off to clear up, a replacement
must be installed temporarily.
The bottom grate can be removed in
order to remove anything that may
clog the inside of the unit. Any chlorine
residue must be removed or it may
effect feeder performance. The grate
helps keep pieces of chemical tablets
from clogging the outlet.
Check o-rings for damage, replace as
needed.
1. Add trichlor tablets in the unit.
2. Increase daily filtration time.
3. If using 3" tabs, use 1" instead.
Contact your pool professional for
more details and actions
Publicidad
